Pool deck resurfacing in Temecula
The deck around the pool wears differently than the pool shell itself. Here are the three common ways to resurface it, national cost ranges by method, and what to check with your HOA and the city before you start.
Coating, pavers, or overlay
A worn, cracked, or hot-to-the-touch pool deck usually gets resurfaced one of three ways:
- Coating. A thin, textured, colored coating applied over the existing concrete to refresh the look, add slip resistance, and in some products reduce surface temperature underfoot. It is a wear layer, not a new structural surface, so it needs recoating over time.
- Overlay. A new cement-based layer poured or sprayed over the old concrete, often stamped or textured to look like stone or tile. It covers more of the deck's existing cracks and wear than a coating does, at a higher cost.
- Pavers. Concrete, travertine, or similar paver units set over or in place of the old deck. The most durable of the three, since a cracked or stained paver can be pulled and replaced on its own, and usually the most expensive because of the material and labor to set each piece.
Which one fits depends on the condition of the existing deck, the look you want, and your budget. A licensed pool builder can tell you whether the deck's existing concrete is sound enough for a coating or overlay, or whether cracking has gone deep enough that pavers or a full tear-out makes more sense.
Start a free request
Pick what you need. Five short questions.
National cost ranges by method
No source used on this site prices pool deck resurfacing in Temecula or the Inland Empire specifically. ConcreteNetwork.com, an industry trade publisher, puts national pool deck resurfacing costs at roughly $4 to $8 per square foot for basic resurfacing (the coating category above), $6 to $12 or more per square foot for decorative overlays, and, installed as a pool deck, about $10 to $30 per square foot for brick pavers and $12 to $45 for concrete or stone pavers. Removing an old deck before replacing it runs another $2 to $6 per square foot on that same source. These are national figures, not a Temecula survey, and they are planning estimates, not quotes.
These deck figures are separate from the pool shell interior (plaster, pebble, tile) ranges in the pool resurfacing cost guide. Do not use one to estimate the other: a deck project and a shell resurfacing are different scopes of work, and a homeowner redoing both should get separate line items from the builder.
If it is the pool shell itself that needs work, not the deck, see pool refinishing and resurfacing cost in Temecula for published national ranges by finish type.
HOA approval and the permit question
If your lot sits inside a homeowners association, deck work can need the same architectural review a pool itself needs, especially if it changes the hardscape footprint, adds new decking, or sits near a property line. See the HOA pool approval checklist for the generic submittal list and what Redhawk Community Association's own guidelines require.
Temecula requires a permit for pools, spas, and hot tubs under its own page, which does not say whether a deck resurfacing job needs its own permit. Ask the builder to confirm that with the city before work starts. See pool remodeling and resurfacing for the fuller permit picture by city.
Pool deck resurfacing questions
Which is cheapest: coating, overlay, or pavers?
By the national per-square-foot figures above, coating is typically the least expensive, overlays cost more, and pavers cost the most. Condition of the existing deck and the design you want move the number more than the category name does. Get a written price for your deck.
Does deck resurfacing cost the same as resurfacing the pool itself?
No. The deck and the pool shell interior are different surfaces with different materials and different cost ranges. See the pool resurfacing cost guide for the shell interior figures, which this page does not use for the deck.
Do I need HOA approval for deck work?
Often, especially if the project changes the footprint or adds decking. Rules vary by HOA. Check the HOA pool approval checklist and your own association's current guidelines before you book anything.
Talk with a licensed pool builder
Call, or send a request with your address. We pass your request to a licensed pool builder who serves Temecula, Murrieta, and French Valley, if one is available. Say whether you want a new pool, a spa, or work on a pool you already have.